How to set up above ground pool on unlevel patio

How to set up above ground pool on unlevel patio how to#

Grading: Poor grading before the installation of an above-ground swimming pool on unstable soil. Holes: Fill in any holes surrounding the pool with concrete to make sure they donвЂ™t act as an imbalance point for leaning pools

itвЂ™s possible that some dirt got under the edge of the liner as it was being installed. You will need to do an assessment of what caused the problem and then take steps that are necessary in order for your pool to be level again.Дirt: Check to see if there are any obstructions in the ground under your pool. In many cases, the cause of this misalignment may require you to make some changes in order for your above-ground swimming pool to be usable again. When a pool is not level, it can be difficult to use.

How to set up above ground pool on unlevel patio how to#

How To Prevent Uneven Water Level in Above Ground Pools?

Use the leveler tool for an accurate measurement. Once you have adjusted the level at one end of your pool, repeat the process on the other sides that your pool needs leveling. The height of your pool should be adjusted inch by inch until the bubble level is at the center. At the center of the leveler tool is a bubble level indicator. Once you have the pool at the desired height, measure with your leveler tool. Once you have lifted the pool, depending on the sagging inch, add or remove blocks.ДЄvoid placing your fingers underneath the pool base when adding or removing weights, as they may slide out or fall down, causing injury.ДЇor safety purposes, always wear heavy-duty mechanic work gloves for protection. If itвЂ™s just a little high, remove the existing blocks or add small pavers under the legs to level it out. If your pool is too low, then you need to add some more blocks. First, place the floor jacks under the pool and fit your plywood lifting the legs of the pool. This will be a little easier if you have another person to help out. Once you have identified which side of your pool is sagging, you can start lifting it up. Choose a strap that is strong enough to hold the weight of your pool. Ratchet straps can be used to secure the side of your above-ground pool.Д«y doing this, the legs would be prevented from bulging out from pressure to one side. You need a ratchet strap if you are not already using one. Once you know where your levels sit relative to one another, then itвЂ™s time to level your pool. This can help calculate the slope of your pool based on its dimensions.

Using both measurements, subtract them.Take a measurement of the water depth at the opposite end of the pool.Take a measurement of the water depth in one corner of the pool.The first step to level an above-ground pool is to determine how level your pool currently is. Best Way to Level an Above Ground Pool Without Draining Leveler Tool: To check if both sides of the pools are leveled properly. Create two wooden legs that can go in between the pool legs and serve as a support when lifting with a floor jack.

Measure the width and height of your pool legs. Two by Two Wooden Leg: This piece is used to lift the side of your pool using a floor jack. Pavers:В Buy some pavers to put under the leaning side which can get from your local store for around 70 cents.ДЇloor Jack: A heavy-duty floor jack to lift the pool. To prevent this, we recommend installing a ratchet strap around the whole pool. Ratchet Strap: The legs of your pool may bulge out if the water is leaning to one side.